The production process of Aluminobond aluminum panel has the following procedures: ingredients — cutting — planing — cutting Angle — bending — forming plate — reinforcing — reinspection.

Ingredients:

Select the data model, specification and color according to the order received by the factory, and then transport to the cutting machine before cutting.

Cutting:

The direction should be accurate when cutting . At the end of the cutting, check to see if it is in accordance with the specifications. Then the plate should be placed gently in the clean channel to clean to prevent the plate surface from being damaged.

Planing groove:

when planing, it is important to pay attention to the processing of the single diagram for re-analysis, confirmation and finalization.

Cutting Angle:

Punching on the angle grinder, the cutting Angle is not allowed to exceed the center line of the groove.

Bend:

Be careful not to repeat the bending, bending twice more to prevent fatigue damage.

Group boards and reinforcements:

It should be noted that the panel process cannot damage panel finish.

Reinspection:

Conduct reinspection of the finished aluminum plastic board to prevent the defective products from leaving the factory.

Aluminobond is specialized manufacturer of aluminum composite panels in China. In addition, Aluminobond was granted “ISO 9000 Quality Management System Certification”, “Occupational Health and Safety OHSAS18001”, “ISO 14000 Environment Management Certification”and “Social Responsibility BSCI International Certification”.